idw – Informationsdienst Wissenschaft
Nachrichten, Termine, Experten
Nachrichten, Termine, Experten
Fraunhofer IZFP offers its customers and research partners the entire range of nondestructive testing technologies, whether it involves basic or applied research. The institute's researchers, engineers and technicians develop solutions to address modern testing applications including feasibility studies, consulting, training and inspection services and creating prototype systems. From June 13 to 17, 2016, our researchers and engineers present the next generation of automated inspection systems for railway wheels at the World Conference on Non-Destructive Testing (WCNDT) in Munich.
Railway wheels are exposed to great dynamic stress. For this reason, they need to be subjected to non-destructive testing during the manufacturing process with the aim of detecting material flaws that may have been caused during manufacture.
In accordance with the current state of technology, the testing is carried out using automated inspection systems.
The challenge was to design a system which guarantees a sensitivity of FBH 1 mm, a dead zone of 5 mm beneath the test surfaces and a cycle time between 60 to 90 seconds.
This makes high demands on the ultrasonic inspection technology. To reduce the mechanical outlay, allow optimum coverage of the prescribed inspection areas and enable flexible configuration of the inspection technology with regard to the wide range of different wheel geometries, phased array probes are used for the inspection of the wheel rim and wheel hub, whilst squirter probes guided by robots are used for the inspection of the discs.
In order to be able to cover the prescribed inspection areas when the beam is being directed into the rim axially and radially and into the hub from both sides for all the wheel types occurring at the manufacturer's works, phased array probes designed specially for this inspection problem, with 64 and 128 elements (linear arrays), have been developed. In the case of the hub in particular, the challenge consisted in finding a suitable configuration of the phased array probes, in order at the same time to cater to both the small dead zone and the large inspection area of up to 300 mm within a single test cycle. It was also necessary to develop a suitable probe carrier which would make constant coupling possible through a water gap in spite of the large active aperture of the probes.
In wheel requalification, examination of the disc is also required. Here the challenge involves recording the geometry, which may be complex, and then carrying out the inspection. Contoured wheel discs in particular make it more difficult to determine the contour data and carry out the ultrasonic inspection, and call for solutions that are sophisticated in terms of the inspection technology they use. This paper aims to provide an introduction to robot-aided contour recording and ultrasonic testing using squirter probes.
Next Generation Train
Source: DLR
Criteria of this press release:
Business and commerce, Journalists, Scientists and scholars
Economics / business administration, Materials sciences
transregional, national
Miscellaneous scientific news/publications, Scientific conferences
English
Next Generation Train
Source: DLR
You can combine search terms with and, or and/or not, e.g. Philo not logy.
You can use brackets to separate combinations from each other, e.g. (Philo not logy) or (Psycho and logy).
Coherent groups of words will be located as complete phrases if you put them into quotation marks, e.g. “Federal Republic of Germany”.
You can also use the advanced search without entering search terms. It will then follow the criteria you have selected (e.g. country or subject area).
If you have not selected any criteria in a given category, the entire category will be searched (e.g. all subject areas or all countries).
