idw – Informationsdienst Wissenschaft

Nachrichten, Termine, Experten

Grafik: idw-Logo
Science Video Project
idw-Abo

idw-News App:

AppStore

Google Play Store



Instance:
Share on: 
05/03/2017 10:53

A laser for divers

Melanie Gauch Marketing & Communications
Laser Zentrum Hannover e.V.

    Working under water is personnel- and time-intensive. The Laser Zentrum Hannover e.V. (LZH) is therefore working on developing a laser-based, automated process for cutting sheet piling under water, together with the Institute of Materials Science of the Leibniz Universität Hannover.

    Sheet piling protects fortified shore areas, or can be used to dry out these areas if repairs are necessary. If the sheet piling must be dismantled, divers must cut the walls into smaller pieces using a cutting torch. Normally, a diver can cut about 20 meters a day, which corresponds to a speed of about 0.07 meters per minute. In the project LuWaPro, scientists at the LZH have now developed a process which uses a disc laser for torch cutting. The divers thus only carries out a supervisory role. The process can be used to separate the metal sheets, which are usually 10 mm thick for sheet piling, at speeds of up to 0.9 m/min.

    Robust process despite unfavorable conditions

    Poor visibility, currents or uneven surfaces make working underwater more difficult. The scientists of the Underwater Technology Group achieved a position tolerance of about two millimeters in their process, enabling the system to react robustly to possible impacts during underwater operation. The process was tested with two scenarios: On the one hand, standalone metal sheets were cut underwater, on the other hand, the sheets were backfilled with concrete. In the second scenario, a leaking of the molten material through the cutting kerf is achieved by tilting the laser head at an angle of 20 degrees.

    Through cuts?

    A further major advantage in comparison to the hand-guided process is the possibility of monitoring the process. Sensors reliably determine whether a cut is completed or not. Otherwise the diver often cannot see this due to the poor visibility underwater.

    Safe laser cutting under water

    The laser safety necessary for this process can be guaranteed if the diver wears conventional safety goggles under the helmet.

    The project “Laser cutting under water for high productivity – LuWaPro” was supported by the Federal Ministry for Economic Affairs and Energy.

    Three figures and one video are available for this press release.


    Images

    Laser cutting of sheet piling under water.
    Laser cutting of sheet piling under water.
    Photo: LZH
    None

    Metal sheets can be cut underwater by using a laser
    Metal sheets can be cut underwater by using a laser
    Photo: LZH
    None


    Criteria of this press release:
    Business and commerce, Journalists, Scientists and scholars
    Mechanical engineering
    transregional, national
    Research projects, Research results
    English


     

    Laser cutting of sheet piling under water.


    For download

    x

    Metal sheets can be cut underwater by using a laser


    For download

    x

    Help

    Search / advanced search of the idw archives
    Combination of search terms

    You can combine search terms with and, or and/or not, e.g. Philo not logy.

    Brackets

    You can use brackets to separate combinations from each other, e.g. (Philo not logy) or (Psycho and logy).

    Phrases

    Coherent groups of words will be located as complete phrases if you put them into quotation marks, e.g. “Federal Republic of Germany”.

    Selection criteria

    You can also use the advanced search without entering search terms. It will then follow the criteria you have selected (e.g. country or subject area).

    If you have not selected any criteria in a given category, the entire category will be searched (e.g. all subject areas or all countries).