idw - Informationsdienst
Wissenschaft
• An international research team has calculated the potential for material efficiency strategies in residential buildings and passenger cars.
• Up to two-thirds of global emissions could be saved in these areas, provided that appropriate strategies are consistently implemented.
More efficient use of materials in residential buildings and cars could save enormous amounts of greenhouse gas emissions by 2050: 20 to 52 gigatons of CO2 equivalents for residential buildings and 13 to 26 gigatons of CO2 equivalents for cars, which amounts to up to two-thirds of current consumption. This is the conclusion reached by a research team led by Dr. Stefan Pauliuk, Assistant Professor of Sustainable Energy and Material Flow Management at the University of Freiburg. For this purpose, the scientists analyzed ten global strategies for material efficiency (ME), such as the reuse of scrap from manufacturing, and calculated their joint maximum potential if they were consistently implemented by 2040 and flanked by a strict climate policy. In the case of residential buildings, wood construction and reducing the living space per capita show the greatest savings potential. For passenger vehicles, it’s ride-sharing and car-sharing. “This shows that material efficiency can be a key to becoming largely carbon neutral,” says Pauliuk. “The potentials are enormous and should be used more.” The research team recently presented its findings in the journal Nature Communications.
What if scenarios for various degrees of material efficiency
In team of international researchers, including Prof. Dr. Edgar Hertwich from the Norwegian University of Science and Technology/Norway, Pauliuk looked at the life cycles of materials for housing and car construction and calculated how many greenhouse gas emissions could be saved by 2050 through a broad and ambitious introduction of material efficiency (ME) measures in combination with a strict climate policy. The calculation considers ten ME strategies. These include supply-side measures, such as reusing scrap from manufacturing; demand-side measures, such as reusing products; and more efficient use of products through car sharing and shared housing. Alongside this, the scientists determined the future changes in material flows and energy consumption due to higher material yields, lighter design, material substitution, longer service life, higher service efficiency, reuse and recycling. In doing so, the computational model captures the production, demand, use and recycling of six climate-relevant materials: aluminum, cement, copper, plastics, steel and wood. “The analysis generates a range of what-if scenarios for various degrees of material efficiency in the vehicle and building sectors and associated key material cycles against different socioeconomic and climate policy backgrounds,” Pauliuk explains.
Material efficiency must be given higher priority in climate policy
According to the researchers, their study shows that renewable energy alone is not enough to achieve deep emission reductions in the residential sector, but that additional efficiency measures are needed. The same applies to passenger cars, where electrification and conversion to low-carbon electricity must go hand in hand, they say. Pauliuk concludes, “If material efficiency strategies are given a similarly high priority as energy efficiency measures, achieving the Paris goal of limiting global warming to well below 2°C will be easier. Measures to improve material efficiency can be easily implemented, so they should be given higher priority in climate policy.”
The research project was supported by the State Ministry of Baden-Württemberg for Science, Research and the Arts, the Israeli Science Foundation and the United Nations Environment Programme.
Assistant Professor Dr. Stefan Pauliuk
Faculty of Environment and Natural Resources
University of Freiburg
Tel.: 0761/203-98726
E-Mail: stefan.pauliuk@indecol.uni-freiburg.de
Twitter: @StefanPauliuk
Pauliuk, S., Heeren, N., Berrill, P., Fishman, T., Nistad, A., Tu, Q., Wolfram, P., Hertwich, E. G. (2021): Global Scenarios of Resource and Emission Savings from Material Efficiency in Residential Buildings and Cars. In: Nature Communications. DOI: 10.1038/s41467-021-25300-4
https://www.pr.uni-freiburg.de/pm-en/press-releases-2021/material-efficiency-hol...
Criteria of this press release:
Journalists, Scientists and scholars
Environment / ecology, Materials sciences
transregional, national
Research results, Scientific Publications
English
You can combine search terms with and, or and/or not, e.g. Philo not logy.
You can use brackets to separate combinations from each other, e.g. (Philo not logy) or (Psycho and logy).
Coherent groups of words will be located as complete phrases if you put them into quotation marks, e.g. “Federal Republic of Germany”.
You can also use the advanced search without entering search terms. It will then follow the criteria you have selected (e.g. country or subject area).
If you have not selected any criteria in a given category, the entire category will be searched (e.g. all subject areas or all countries).