idw – Informationsdienst Wissenschaft

Nachrichten, Termine, Experten

Grafik: idw-Logo
Science Video Project
idw-Abo

idw-News App:

AppStore

Google Play Store



Instanz:
Teilen: 
18.08.2023 12:40

Microscopic Transformations of Electrocatalyst Surfaces

Eva Sittig Presse, Kommunikation und Marketing
Christian-Albrechts-Universität zu Kiel

    Joint press release of Kiel University and the Fritz Haber Institute of the Max Planck Society

    Researchers from Kiel and Berlin reveal the disordering of copper surfaces during catalysis

    Developing technologies that can convert CO2 into synthetic fuels and base chemicals is of key importance for reaching the climate goals. The electrochemical reduction of CO2 at copper electrodes allows to do this directly with electric power from renewable sources which could be used for the production of e-fuels. New studies show that this process changes the arrangement of the copper atoms at the catalyst surface.

    Copper is an indispensable catalyst material for CO2 reduction, especially for the synthesis of particular valuable chemicals and fuels, such as ethanol. For this, it is highly favorable, if the copper atoms at the surface have a strongly disordered arrangement. The latter can be achieved for example by pre-oxidizing the copper surface or through alloying. In a joint study of the Institute of Experimental and Applied Physics of Kiel University and the Department of Interface Science at the Fritz Haber Institute (FHI) of the Max Planck Society (MPG) such disordered structures turned out to form also spontaneously in the very initial stages of the electrocatalytic CO2 reduction reaction. The researchers observed that copper atoms inside the metal moved towards the surface and assembled into a freestanding group of only a few atoms. This transformation of the metal was caused by CO, an intermediate product of the reaction, and was preserved even at high reaction rates. The results were published today in the renowned scientific journal Nature Catalysis.

    “Because the electrocatalytic CO2 reduction occurs at metals in aqueous carbonate solution similar to mineral water, and is accompanied by the formation of hydrogen gas, detailed investigations of the process on the atomic scale is difficult”, says Olaf Magnussen, Professor for Solid State Physics at Kiel University.

    The researchers therefore used a combination of methods that can be employed even under these challenging conditions. The team from Kiel observed the transformation of the copper surface directly by high-resolution electrochemical scanning tunneling microscopy (see Figure 1). This method allows direct imaging of the atoms and molecules at the surface. X-ray diffraction studies, performed by scientists from Kiel and Berlin at the PETRA III synchrotron of DESY in Hamburg confirmed this transformation. In addition, these measurements showed that at high reaction rates the freestanding copper atoms were maintained, but no further formation occurred. Molecular spectroscopy at the Fritz Haber Institute finally indicated that the changes were induced by the formed CO.

    “The results suggest a drastic transformation of the electrode surface each time that the electric current required for the CO2 reduction is switched on. This was previously unknown, but could play an important role in catalysis”, says Professor Beatriz Roldán Cuenya, Director of the Interface Science Department at FHI. One strategy to influence the structure of the catalyst and thus the type of formed chemical compounds is to operate the electrode with voltage pulses. Indeed, this had been shown already in previous work of the research team. However, the copper there was periodically oxidised by means of electrical energy, which requires the polarity of the electrode to be reversed. According to the new results, similar effects might be obtained already by simply switching the current on and off. “Overall, the study confirms our hypothesis that not only the electrode material but also the operating conditions and micro-environment are relevant for the realization of this environmentally friendly technology”, says the team.


    Wissenschaftliche Ansprechpartner:

    Prof. Dr. Olaf Magnussen
    Solid State Physics
    Institute of Experimental and Applied Physics
    Kiel University
    +49 431 880-5579
    magnussen@physik.uni-kiel.de

    Prof. Dr. Beatriz Roldán Cuenya
    Director Interface Science Department
    Fritz Haber Institute of the Max Planck Society
    +49 30 8413-4123
    roldan@fhi-berlin.mpg.de


    Originalpublikation:

    Atomic-scale surface restructuring of copper electrodes under CO2 electroreduction conditions, R. Amirbeigiarab, J. Tian, A. Herzog, C. Qiu, A. Bergmann, B. Roldan Cuenya, O.M. Magnussen, Nature Catal., accepted (2023); https://doi.org/10.1038/s41929-023-01009-z


    Weitere Informationen:

    https://www.uni-kiel.de/en/details/news/206-katalyse Link to the press release
    https://www.fhi.mpg.de/isc-department Website Interface Science Department, Fritz Haber Institute (FHI) of the Max Planck Society
    https://www.physik.uni-kiel.de/de/institute/ieap Institute of Experimental and Applied Physics, Kiel University
    https://www.kinsis.uni-kiel.de/en Priority Research Area KiNSIS (Kiel Nano Surface and Interface Science), Kiel University


    Bilder

    Merkmale dieser Pressemitteilung:
    Journalisten, Wissenschaftler
    Physik / Astronomie
    überregional
    Forschungsergebnisse, Wissenschaftliche Publikationen
    Englisch


     

    Hilfe

    Die Suche / Erweiterte Suche im idw-Archiv
    Verknüpfungen

    Sie können Suchbegriffe mit und, oder und / oder nicht verknüpfen, z. B. Philo nicht logie.

    Klammern

    Verknüpfungen können Sie mit Klammern voneinander trennen, z. B. (Philo nicht logie) oder (Psycho und logie).

    Wortgruppen

    Zusammenhängende Worte werden als Wortgruppe gesucht, wenn Sie sie in Anführungsstriche setzen, z. B. „Bundesrepublik Deutschland“.

    Auswahlkriterien

    Die Erweiterte Suche können Sie auch nutzen, ohne Suchbegriffe einzugeben. Sie orientiert sich dann an den Kriterien, die Sie ausgewählt haben (z. B. nach dem Land oder dem Sachgebiet).

    Haben Sie in einer Kategorie kein Kriterium ausgewählt, wird die gesamte Kategorie durchsucht (z.B. alle Sachgebiete oder alle Länder).